Radix epsilon Manual de instrucciones descargar pdf (Pagina 23)

Version 1.0 Page 23

6.7.3 Adding Another Satellite

If you would like to add another satellite to those that have been factory-installed, then you will have to

perform the following procedures before undertaking the procedures stated under 6.7.2 above:

• In the "Transponderdate – Edit" menu, highlight the line immediately beneath

the last satellite listed and confirm your selection by pressing the MENU-key.

MENU/EXIT

Transponderdate - Edit

ABC8

18 SIRIUS1 2

19 AMOS 1

20 TELECOM2B

21 NILESAT

22 -

\TPH/VSR

• Enter the name of the satellite involved, which consists of a maximum of

12 alphanumeric characters, into the middle line by using the -key or -key

to highlight the position involved and then using the -key or -key to select

the letter required or the numerical keys to enter the numeral involved.

• Confirm your entry by pressing the MENU-key, which will automatically acti-

vate the revised table.

• Enter all of the necessary data, following the procedures stated under

Section 6.7.2, above

6.7.4 Editing Transponder Data

NOTE:

You may edit or delete only transponder data that you have entered yourself.

Factory-preset transponder data cannot be edited or deleted.

• To edit transponder data, first highlight the line to be edited and then proceed

as stated under Section 6.7.2 or 6.7.3, above.

• Overwrite the data listed, item by item.

• Either press the EXIT-key to abort editing or press the MENU-key to confirm

the editing you have done.

Programming Your Receiver

…

EXIT

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Sin comentarios

Radix epsilon Manual de instrucciones Pagina 23