Radix epsilon Manual de instrucciones descargar pdf (Pagina 12)

Programming and Operating the Analog-Receiver Section

Page 12 Version 1.0

6 Programming and Operating the Analog-Receiver Section

•

Switch the receiver on by pressing the ON/OFF-key.

• Press the A/D-key on the remote control in order to switch

from using the receiver’s digital section to using its analog

section.

NOTE:

You may suppress the picture for the current channel and obtain a blue screen by

pressing the BACK-key, if desired. The system menu will be displayed onscreen

even in the absence of an input signal.

• You may also suppress the sound track for the current channel

by pressing the MUTE-key, if desired, in which case the message

“SOUND OFF“ will appear onscreen. Pressing the MUTE-key a

second time will restore the sound track.

6.1 Setting the Basic Parameters from the System Menu

• Simultaneously press the p and q keys on the receiver’s

front panel while the receiver is in standby mode and hold

them depressed for 3 seconds.

The following menu will then be displayed onscreen:

• Use the p and q keys to shift the cursor to the desired position

(the highlighted display line).

• Use the t and u keys to select the desired setting.

• Select the desired language (Deutsch, English, Français, Italiano).

• Select an LNB-local-oscillator frequency of 9.75 GHz/10.00 GHz.

• Adjust the local-oscillator frequency in steps of 0.25 MHz until it

agrees with your LNB (the available frequency-adjustment range

is ± 15.00 MHz).

• Select “ON” if you intend to use the receiver’s SMATV-feature

(DiSEqC Version 1.0)

• Press the STORE-key.

The data have now been saved and the receiver will automatically switch off.

LANGUAGE : ENGLISH

DRO SHIFT : 00.00MHZ

LNB FREQ. : 9.75GHZ

SMATV : OFF

SYSTEM MENU

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 34 35

Sin comentarios

Radix epsilon Manual de instrucciones Pagina 12