Radix epsilon Manual de instrucciones descargar pdf (Pagina 26)

Setting Up and Programming the Digital Receiver

Page 26 Version 1.0

7.6.4 Conducting a Manual Search

Once the settings of Sections 7.6.1 through 7.6.3, above, have been concluded, you may initiate a

manual search.

• Use the p and q keys to highlight the “Start Search“ field.

• Press the MENU-key to start the search.

While the search is in progress, a clock will appear at the lower right-hand corner of

the screen. You will also see a blue bar indicating the extent of the frequency band

that has thus far been searched. The other items appearing onscreen have the

following meanings:

DF: .... - The satellite downlink frequency involved

SR:.... - The symbol rate

New:... - The total number of new channels saved to the receiver’s memory

Once the search has been successfully concluded, the message “Search OK“ will

appear onscreen.

• Press the EXIT-key to exit the menu and view the

channel found.

If the search fails to locate a channel, one of the following error messages will

appear onscreen:

“Tuning fail“ - Check the symbol rate.

“Search fail“ - Check the local-oscillator frequency, the signal

strength, the 22-kHz setting, and the choice of satellite

to be involved.

“No free channel“ - Check the downlink frequency.

“Search cancel“ - The search was cancelled by pressing the EXIT-key

before the search could be concluded.

EXIT

Setup Value

Down Frequency

Manual Search

1 - 3 - 6 - 4

Symbol Rate

DF:4000 SR:28.125 New:18

LNB Polarity

Start Search

Search OK

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 34 35

Sin comentarios

Radix epsilon Manual de instrucciones Pagina 26