Radix epsilon Manual de instrucciones descargar pdf (Pagina 22)

Setting Up and Programming the Digital Receiver

Page 22 Version 1.0

7.5.3 Entering the Low-Noise Block (LNB) Converter’s Local-Oscillator Frequency

Commercially available satellite systems employ so-called “general-purpose” LNB’s that employ a local-

oscillator frequency of 10,600 MHz for their upper band. In the event that your LNB uses some other

local-oscillator frequency, you may set up your receiver to accommodate it as follows:

• Use the p and q keys to highlight the “LNB Local Freq“ field:

• Press the MENU-key.

• Use the numerical keys to enter the local-oscillator frequency

employed by your LNB.

• Press the MENU-key to confirm your entry.

7.5.4 Checking Signal Strength

You should check the alignment of your satellite antenna on a regular basis if you want to have the best-

possible reception.

• Use the p and q keys to highlight the “Signal Strength”

field and then press the MENU-key.

The legend “[STATUS]” will appear onscreen for a few seconds, when it will be

replaced by “[LOCK],” accompanied by a triangular figure. If the latter has only

yellow and red segments, then the received signal strength is weak.

MENU/EXIT

Setup Value

Satellite

Installation

1 - 3 - 3

Signal Stength

DiSEqC/22KHz Auto Search

LNB Lokal-Freq Manual Search

5150 MHz

EXIT

Setup Value

Satellite

Installation

1 - 3 - 4

Signal Strength

DiSEqC/22KHz Auto Search

LNB Lokal-Freq Manual Search

SNR

[STATUS]

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 34 35

Sin comentarios

Radix epsilon Manual de instrucciones Pagina 22