Radix epsilon Manual de instrucciones descargar pdf (Pagina 34)

Programming the Remote Control

Page 34 Version 1.0

9 Programming the Remote Control

The remote control may be programmed using two different methods, either by entering a three-digit

manufacturer’s code (manufacturer’s ID) taken from the addendum or by means of a systematic search.

Method 1: Entering the Manufacturer’s Code:

Step 1: Press the SET-Taste and hold it depressed for about 3 seconds until

the red LED illuminates.

Step 2: Press the key for the type of device to be controlled:

SAT Analog satellite receivers

DVB Digital satellite receivers

TV Television sets

VCR Video cassette recorders

Step 3: Look up the manufacturer’s code for the particular model to be

controlled in the addendum, which will be listed under the

manufacturer’s name. If more than one code is listed, try out each of

them in turn.

Switch on the device to be controlled.

Point the remote control at that device.

Enter (one of) its three-digit manufacturer’s code(s) using the numerical

keys. The device will switch off if the code entered is the correct one.

Step 4: Press the SET-key to save the entry. The red LED will blink three times

and then be extinguished.

If nothing happens, repeat Steps 1 through 4 using another choice of

manufacturer’s code.

Method 2: Systematic Search:

Step 1: As for Method 1.

Step 2: As for Method 1.

Step 3: Switch on the device to be controlled.

Point the remote control at that device.

Repeatedly press the red ON/OFF-key and continue repeatedly

pressing it until the device switches off.

NOTE:

Many devices are rather slow to switch off. You should thus wait a few seconds to

see if the device switches off between presses of the ON/OFF-key.

1 2 ... 29 30 31 32 33 34 35

Sin comentarios

Radix epsilon Manual de instrucciones Pagina 34