Radix epsilon Manual de instrucciones descargar pdf (Pagina 14)

Programming and Operating the Analog-Receiver Section

Page 14 Version 1.0

6.3 Preselecting Channels from the Main Menu (Display Page 2)

• Press the q key to exit Display Page1 and call up

Display Page 2.

• Use the t and u keys or numerical keys to adjust/reset

the left-channel audio-subcarrier frequency.

Before the right-channel audio-subcarrier frequency can be adjusted or reset, L/R

must be set to “FREE.” To make this adjustment, proceed as follows:

• Use the t and u keys or the numerical keys to set the

desired right-channel audio-subcarrier frequency.

• Select audio deemphasis and the desired bandwidth:

STEREO/ADAPT – MONO/ADAPT –

MONO/50u – MONO/J17.

If the deemphasis parameters have been set to “MONO,” you may select an audio

bandwidth of 150/280/400/600 kHz.

• Set the L/R channel separation to “FREE” or 180 kHz.

If this has been set to “FREE,” the bandwidths of the left and right audio channels

may be independently adjusted or reset. If it has been set to 180 kHz, the

bandwidth for the right channel will automatically track that set for the left channel.

• Select “AUDIO EXTERNAL” (i.e., via a Scart loop) or

“AUDIO INTERNAL,” which will only be possible if

“DECODER” has been set to a setting other than “NONE.”

• Select “RADIO ON” if you would like to have a black screen

while listening to the radio.

AUDIO L : 7.02MHZ

R : 7.20MHZ

DE-EMPH : STEREO/ADAPT

B/W : 150KHZ

L/R DIST. : 180KHZ

AUDIO : INTERNAL

RADIO : OFF

MAIN MENU

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 34 35

Sin comentarios

Radix epsilon Manual de instrucciones Pagina 14