Radix epsilon Manual de instrucciones descargar pdf (Pagina 13)

Programming and Operating the Analog-Receiver Section

Version 1.0 Page 13

6.2 Preselecting Channels from the Main Menu (Display Page 1)

• Press the MENU-key on the remote control while the

receiver is switched on.

The following menu will then be displayed onscreen:

• Either use the t and u keys to select a channel/broadcaster,

• enter a 3-digit channel number.

• If necessary, reset the local-oscillator frequency

(5.15 GHz/9.75 GHz or 10.00 GHz/10.60 GHz).

If your antenna is capable of receiving C-band broadcasts, you may reconfigure the

receiver setup in order to allow receiving them by using a setting of C-05.15 GHz.

• Use the t and u keys or the numerical keys to adjust/reset

the channel frequency to the desired value (cf. the addendum

for a list of available channel frequencies).

• Select either horizontal or vertical polarization.

• Switch the 22-kHz control frequency ON or OFF.

• Select the desired decoder status (NONE/MAC/PAL1/PAL2).

• Select the desired picture contrast.

• Switch the child-protection feature ON in order that the channel

selection can only be altered by a numerical entry, and can no

longer be altered using the p and q keys.

While the cursor ( > ) is in the bottom display line, you may use the q key to switch

to the next menu. While it is in the top display line, pressing the p key will return

you to the preceding menu.

CHANNEL : 400

BAND : KU-09.75GHZ

FREQ. : 12150.00MHZ

POLARITY : HORZ.

22KHZ : OFF

DECODER : NO

CONTRAST : 5

P. LOCK : OFF

MAIN MENU

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 34 35

Sin comentarios

Radix epsilon Manual de instrucciones Pagina 13